Top 10 common forklift accidents ， forklift operation should pay attention to these matters ！.

Don't underestimate the forklift at the office. If the operation is not good, there will certainly be severe crashes in mins, and there are several crashes entailing forklifts.

Situation 1: The forklift freight obstructed the vehicle driver's view, and the individual ahead might not be located, resulting in a rolling mishap.
Case 2: In order to preserve the balance of the forklift when raising heavy products, the employees utilized their body weight as the weight, which virtually caused casualties.
Instance 3: The width of the forklift cargo goes beyond the permitted width of the course and holds on the roadside rack, which practically causes an accident.
Instance 4: Forklift is speeding and surrender throughout a turn.
Situation 5: The forklift motorist did not notice the pedestrian, and the pedestrian did not see the forklift.
Instance 6: The forklift lifts the employees illegally, the forklift driver does not put on the safety belt, the forklift lifter drops and the driver is crushed when the forklift rolls over.
Situation 7: The forklift chauffeur did not use a safety belt and fell from the lorry when it surrendered and was crushed.
Forklift procedure need to focus on these issues ：.

Begin.
1. Before starting, observe the environments, and after validating that there are no obstacles that hinder the security of driving, beep the horn first and after that begin.
2. For cars with hydraulic (air pressure) brakes, the brake hydraulic pressure (air pressure) scale must be risk-free prior to starting.
3. When the forklift starts with a lots, the chauffeur must initially verify that the lots is secure and reliable.
4. The beginning must be slow-moving and steady.

Driving.
1. When driving, the elevation between the bottom end of the fork and the ground need to be maintained 300mm-400mm, and the pole needs to be slanted backward. .
2. Do not lift the fork too expensive when driving. When entering and leaving the work website or while driving, be careful that there will be no challenges in the sky. When the lots is traveling, the fork must not be raised expensive, which will certainly influence the stability of the forklift. .
3. After dumping, the fork should be decreased to the normal driving position prior to driving. .
4. When turning, if there are pedestrians or cars close by, the driving signal needs to be issued first. High-speed doglegs are prohibited. High-speed doglegs will cause the car to shed lateral security and topple. .
5. When the forklift is downhill, it is strictly forbidden to switch off the fire and slide, and it is prohibited to brake suddenly while driving with loads unless there are unique situations.
6. When the forklift is running, it must comply with the web traffic rules in the manufacturing facility and must maintain a specific security range from the vehicle ahead. .
7. When the forklift is running, the tons should remain in the lowest position that does not prevent the driving, and the gantry must be appropriately tilted back. The tons will not be raised except when piling or loading. .
8. The elevation of the load need to not obstruct the vehicle driver's view. In unique scenarios, when the product impacts the forward vision, drive at a low speed when reversing.
9. It is restricted to activate the ramp, neither to drive across the ramp. .
10. The safe driving speed of the forklift in the manufacturing facility location is 5 km/h, and it needs to drive safely at a low rate when going into the production workshop area. .
11. When the forklift is raised, raised or driven, it is prohibited for personnel to depend on the fork to hold things and play a balancing role. .
12. If troubles are located, they will be repaired and reported in a prompt way, and they will never ever operate with diseases or hide them.

packing and unloading.
1. When fork-loading items, the range between both forks must be adjusted as required to make the tons of the two forks well balanced and not skewed, and one side of the thing need to be against the shelf. .
2. It is prohibited to work with a solitary fork or utilize a fork top or draw. In special circumstances, safety and security warning signs have to be set up to advise surrounding pedestrians. .
3. In the process of filling and discharging items, the forklift needs to be braked with the brake. .
4. The rate of the vehicle must be slow and consistent. Be careful not to roll the wheels on the dunnage, so as not to extend the rolled objects and harm individuals. .
5. When utilizing a fork to fork the goods, the fork needs to be as deep as possible under the lots, and it should be kept in mind that the fork tip ought to not touch various other goods or items. The lots ought to be maintained with minimal back tilt of the gantry to ensure that the lots does not slide backwards. The pole can be tilted forward somewhat when the lots is lowered to allow for simple positioning of the load and extraction of the forks. .
6. It is restricted to fork items at high speed and hit difficult things with the fork head. .
7. When the forklift is working, it is forbidden for individuals to loaf the fork, so regarding avoid the collapse of the goods and hurt people. .
8. Overwhelming is banned, and it is prohibited to utilize forks to lift workers to take part in high-altitude procedures to avoid high-altitude falling accidents. .
9. It is not enabled to utilize the brake inertia to slide, place, round or roll things. .
10. It is not permitted Electric Forklift Truck for Warehouse to make use Stand-on Electric Pallet Stacker of forks to pick, turn pallet unload.

Leaving .
1. It is forbidden to leave the forklift when the items on the fork are in the air. Before leaving the forklift, you should discharge the goods or lower the fork framework.
2. Pull the emergency brake manage to dead or depress the emergency brake switch.
3. The engine is shut off and the power is cut off. (Except for special situations, such as the chauffeur does not leave the car's line of vision and does not surpass 1 minute).
4. Remove the key. .

Forklift Operation Precautions.
1. Prior to and after the forklift procedure, the look must be inspected, and fuel, lubricating oil and cooling water need to be added.
2. Check the safety performance of beginning, running and stopping.
3. Inspect whether the lights and horn signals are total and efficient.
4. Throughout the procedure of the forklift, check whether the pressure and temperature are normal.
5. After the forklift is running, the external leakage should additionally be examined and the seals ought to be replaced in time.

Forklift Safety Operation Specifications.
1. You have to examine before leaving the vehicle;.
2. When you encounter a person before you during driving, you need to send a signal at a distance of 5 m;.
3. The driving speed in the manufacturing facility does not exceed 5 km/h;.
4. When driving, the nadir of the freight should be 0.3 m ~ 0.4 m in the air;.
5. The turning should not be too sharp to stop the tendency of " cost-free turning";.
6. Adding and down the slope ought to be slow-moving and uniform, and no switching on the slope is allowed.
7. Do not drive throughout the gradient. When the gradient is greater than 10%, the automobile should be driven in reverse when going downhill;.
8. When the forklift employees carry the goods and move on, if they experience huge or hefty goods and go to the chauffeur's line of vision, they need to take the turning around workout
.
The "Eight Prohibitions" should be followed in the procedure.
1. Single fork operation is not allowed.
2. It is not allowed to raise the goods for far away driving.
3. It is not permitted to pick up the goods by handing over the pallet with the fork.
4. It is not permitted to straight shovel chemicals, flammables and other hazardous chemicals with forks.
5. It is not allowed to make use of inertia pressure to get the goods.
6. It is not permitted to make use of stopping pressure to exile round or easy-to-roll items.
7. It is not permitted to bring people to service the pallet or fork, and it is strictly prohibited to stand under the fork after the fork is elevated.
8. Do not drive laterally on inclines
.
Vehicle parking is not allowed under the list below problems.
1. Contours, narrow roadways, train crossings;.
2. Areas with a longitudinal slope above 5%.
3. When there is an obstacle on one side of the road, the contrary side of the section with the very same length as the challenge need to be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844